Dr. Pen M8 Face Combo Cartridges (5-pack)

• Microneedling should be performed every 4-6 weeks
• Perform nanoneedling once a week (ideally in between your microneedling sessions)

• Needles are made from high-quality stainless steel, making it suitable for surgical, pigmentation, deep wrinkle, and acne scarring applications
• Cartridges are designed for single-use only.
• Do not reuse the same cartridge.
• Compatible with the Dr. Pen M8 (device not included)

What’s included?

• 2 x 11-pin cartridge for the Dr. Pen M8 microneedling pen
• 2 x 16-pin cartridge for the Dr. Pen M8 microneedling pen
• 1 x Nano cartridge for the Dr. Pen M8 microneedling pen

*MICRONEEDLING PEN NOT INCLUDED, SOLD SEPARATELY

Important: Microneedling cartridges must be sterilised before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilised. Here are the steps to sterilise microneedling cartridges:

1. First, ensure that you have all the necessary equipment for sterilisation; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
2. Put on your gloves to avoid contaminating the cartridges during the sterilisation process.
3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
4. Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.
5. If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
6. Once the sterilisation is complete, allow the cartridge to air dry before using it.
7. Finally, your cartridge is ready for use.

How to use

• To ensure there is no cross-contamination, cartridges must be sterilised before treatment.
• Fully tie back your hair, away from your face.
• Double-cleanse (cleanse and repeat), then wipe the skin clean with an alcohol wipe.
• Work in small areas and apply the serum (recommended: Femvy Hyaluronic Acid Serum) to each area before needling. This will help to ensure that the pen does not drag or pull on the skin. The recommended pattern to move the pen for best results is vertical, horizontal, and then diagonal in both directions. Using a light pressure and without dragging, repeat this motion over each area two times. 

How to do nano needling

• Start by tying the hair to keep them away from the face. Wash the face using a cleanser to eliminate all makeup, dirt, oil, and other debris on the skin.
• Open the new nano cartridge and carefully attach it to the Dr. Pen device.
• Do not touch the tip of the disposable cartridges to prevent contamination.
• Apply a few drops of a hydrating serum (Femvy Hyaluronic Serum or Femvy Peptide Complex Serum) to the face just before working in small areas.
• Move the microneedling pen in vertical, horizontal, and then diagonal directions.
• It is recommended to work in a grid to ensure that every area is treated well.
• Only put light pressure on the skin when using the device.

• On open wounds. 
• On acne or irritated skin. 
• If irritation occurs.